Hi.
When driving the vehicle over the past few weeks an alert has displayed twice on the display behind the steering wheel saying from memory, "Engine or Vehicle fault - go to service centre" Interestingly the Navigation then displays the local service centres on the map to make it easier for you to navigate there.
The alert has diplayed twice over a period of 1,100km driving both highway and urban. When I continue to drive I have not noticed anything changed or not functioning or diminished power etc on the vehicle.
I don't have an OBDII reader, so in a moment of inspiration I dropped into Supercheap and paid $30 to have the codes read. I have attached the report here. After the initial read I asked for the codes to be deleted, and they waited while I did a lap around the block, and they the read the codes a second time. On this second read there were no codes present.
The report lists 44 fault codes under seven discret vehicle systems. Many of these relate to non cummunication over CAN bus / absence of a datastream issues, and, also supply voltage faults or outside of range.
44 fault codes does seem a lot and my suspicion is that there is a battery voltage issue, that may be causing these codes and also the in-dash alert. Is anyone able to provide some insight or possible cause to the many codes?
Note: the battery is original and has not been replaced. Vehicle was manufactured in May 2017, but Compliance plated in May 2018, (seems odd), so I am assuming that the battery is 5 1/2 years old. This vehicle also has the battery charge status ECU that controls the charging of the battery and the vehicle has a stop/start feature.
Thanks in advance for any assistance.
When driving the vehicle over the past few weeks an alert has displayed twice on the display behind the steering wheel saying from memory, "Engine or Vehicle fault - go to service centre" Interestingly the Navigation then displays the local service centres on the map to make it easier for you to navigate there.
The alert has diplayed twice over a period of 1,100km driving both highway and urban. When I continue to drive I have not noticed anything changed or not functioning or diminished power etc on the vehicle.
I don't have an OBDII reader, so in a moment of inspiration I dropped into Supercheap and paid $30 to have the codes read. I have attached the report here. After the initial read I asked for the codes to be deleted, and they waited while I did a lap around the block, and they the read the codes a second time. On this second read there were no codes present.
The report lists 44 fault codes under seven discret vehicle systems. Many of these relate to non cummunication over CAN bus / absence of a datastream issues, and, also supply voltage faults or outside of range.
44 fault codes does seem a lot and my suspicion is that there is a battery voltage issue, that may be causing these codes and also the in-dash alert. Is anyone able to provide some insight or possible cause to the many codes?
Note: the battery is original and has not been replaced. Vehicle was manufactured in May 2017, but Compliance plated in May 2018, (seems odd), so I am assuming that the battery is 5 1/2 years old. This vehicle also has the battery charge status ECU that controls the charging of the battery and the vehicle has a stop/start feature.
Thanks in advance for any assistance.