I actually bought my S16 from Chevron. As this was basically my 1st purchase from a commercial outlet I probably made some mistakes by showing too much enthusiasm for the car, can you blame me

Anyway I was refered to Peugeotcare through the Pug Club of QLD. It was supposed to be a 110,000km service, however Bob picked up on several problems and only charged about $55/hour labor.
1) The variable inlet track vacume actuators were not working at all, causing a substantial loss in power below 4000rpm, and also making the engine very uneven in power delivery.
2) Bolts on one of the RH axle bearings were not installed...not impressed. Kev Fain motors apparently gave it a $120 road worthy pre-purchase, Cya Kev.
Anyway, now a part of the vacume amplifier which connects the intake actuators, brake booster and another pipe wich goes into the intake has broken, which puts me back to square 1 in power. Rang Bob and he said to bring it in that Friday night...5.30. He tried to sort out the part and make a temp fix for it till 6.30pm that night, and did not ask for any money, but the part is Ex-France, 12 working days... :-( No power till then.
Needless to say from my short experience these guys seem good and I will keep going back there.
------------------
1995 306 S16