Any clues ? Can't get a good pedal on brakes, i've narrowed it down to L/H/R caliper, pinching off the hose gets rock hard pedal with about 20mm travel, un-pinch the hose gets half way to floor spongy as buggary pedal,
I put a new seal kit in to achieve the half way pedal.
Have pushed piston all the way in & clamped it, then bled it again, no air in oil! I placed steel blocks of equivalent thickness to pads & rotor re bled still the same result, I've bled the caliper from all different angles tapping it with a hammer to try to dislodge any air bubbles, still no joy have put 2L of oil thru it so far. Need some ideas PLEASE.
<small>[ 02 October 2002, 08:37 PM: Message edited by: Damien Gardner ]</small>
I put a new seal kit in to achieve the half way pedal.
Have pushed piston all the way in & clamped it, then bled it again, no air in oil! I placed steel blocks of equivalent thickness to pads & rotor re bled still the same result, I've bled the caliper from all different angles tapping it with a hammer to try to dislodge any air bubbles, still no joy have put 2L of oil thru it so far. Need some ideas PLEASE.
<small>[ 02 October 2002, 08:37 PM: Message edited by: Damien Gardner ]</small>