Howdy,
Does anyone (David?) have a good procedure for bleeding air from the R12 cooling system? Or do you just get most of it out, and that's good enough? I basically fill the rad., run the car, top it up to the brim, then put the cap on. Then run the engine at about 1500 rpm (heater on) until it warms up and the thermo. opens, open the bleed screws in turn and release the air. That's it. It this correct?
Cheers
Stuey
Does anyone (David?) have a good procedure for bleeding air from the R12 cooling system? Or do you just get most of it out, and that's good enough? I basically fill the rad., run the car, top it up to the brim, then put the cap on. Then run the engine at about 1500 rpm (heater on) until it warms up and the thermo. opens, open the bleed screws in turn and release the air. That's it. It this correct?
Cheers
Stuey