Just installed this Peugeot 206 iron block engine into a Berlingo which previously had the later alloy 1.4, changed everything electrical but stopping at cutting the exhaust under the gearbox until i solve the poor running.
.
Has one exhaust sensor on the downpipe at present.
I will weld in provision for the extra sensor later.
Does anyone remember if they run reasonably with the open exhaust or does this throw the engine management out?
Or am i looking at another cause.
.
Has one exhaust sensor on the downpipe at present.
I will weld in provision for the extra sensor later.
Does anyone remember if they run reasonably with the open exhaust or does this throw the engine management out?
Or am i looking at another cause.