FREE SHED SALE

[FIVEDOOR]

Yeah….. about that. Not sure yet. Think it will end up on pavers and I’ll probably tie it to the fence like a tent.

Coupled with the alpine it should be sweet

Wheel barrow, water shovel and premix, then straight in the shed. No reo and no more than 70 thick and it will be easy enough to break up if you have to. Given the size of the shed I imagine it will all be relatively light weight stuff, so thin slab should suffice. Pouring the concrete after the shed is erected should make the wall/floor edge waterproof.

 

[Steve K]

What are the thicknesses of the r12/17 front sway bars? R12 limit Valve might be handy, and is the wiper pivot arm the bit on the top? I can’t picture it but have to put an early r12 together soon.

It is a genuine new R12 GORDINI bar. Will need to measure it.
The wiper thingy is at the wiper shaft below the splines and nut where it comes through the scuttle.
has a pin sticking out of it for the secondary link of articulated wipers.
If yours is an early 12, they didn't have it.

AND hey folks, can we stop harping on about sheds and talk about the barrow.?
The barrow load of Renno parts I need to get rid of.!!

 

[DoubleChevron]

AND hey folks, can we stop harping on about sheds and talk about the barrow.?
The barrow load of Renno parts I need to get rid of.!!

I could be intersted. Is it a good heavy duty commercial grade australian made barrow? I need one of them

 

[Steve K]

It is a chinese piece of crap.
Most of it rusted through.
The "tyre" is made out of some kind of plastic that is brittle, the tube leaks
and the rim is so thin that it buckles when you try to remove the tyre.
BUT it is rated for highway use at up to 150 KMH.....

 

[Steve K]

OK now, enough about sheds.
Slight correction = shed is 2.0M deep and 2.3M wide. - SOLD

So let's start with the car stuff ;

Super R5 - the later east west engine version.
New windscreen $300
New GT Turbo front bumper $300
+ Renault aluminium aerodynamic roof bars $150

OR the lot for $500 - Now $300

Alpine A310 / Peugeot 604
NOS twin ignition points set

Alpine GTA
New windscreen $950
Pair new main coolant tubes $550
Pair new front bumper braces $190
New aluminium turbo finned cooler $250
Set black leather seats F & R $1800
Pair door cards $400

Clio circa 2005
Auto transmission $100 or the tip
Rear exhaust section 1.4 $100 or the tip
Cylinder head 1.4/1.6 $100 or the tip
Dash top section $150

OR the lot for $300 - Now $250

R8/10
Windscreen, rubber, chromes $100 (provided I am successful with new replacement on my 8G)
Drivers door shell FTGH

R12
New Old Stock Bosch spark plugs
NOS Ducellier points
NOS Rear wheel cylinders
NOS Pressure limiter valve
NOS Meillor engine gasket set - GONE
NOS rocker cover seals
NOS Wiper pivot plate for articulated version
NOS Gordini front sway bar

$$$$ ???

R17G/TS
NOS Front sway bar
$$$$ ???

R20 TS
5speed manual gearbox opened up for inspection
NOS ignition points.
$$$$ ???

R25 GTX
Pair overhauled front brake callipers - plated "gold"
Some more parts to be advised
$$$$ ???

Laguna V6 cica 1995
Some parts to be advised

Anyone need a fax machine??



More to come.
Inspect, haggle and pickup only from Blackburn Vic.

OK, I'm getting fed up and serious now!
I'm...I'm.. not kidding now.
Goes against my hoarding tendencies, but the trailer is getting loaded for the tip.
I may be persuaded to bring some small items to the Renault Roundup on Feb. 20.
Speak up if interested.

 

[angru]

It is a genuine new R12 GORDINI bar. Will need to measure it.
The wiper thingy is at the wiper shaft below the splines and nut where it comes through the scuttle.
has a pin sticking out of it for the secondary link of articulated wipers.
If yours is an early 12, they didn't have it.

AND hey folks, can we stop harping on about sheds and talk about the barrow.?
The barrow load of Renno parts I need to get rid of.!!

What’s the cost of the bar? I don’t think I’d seen your reply to when I asked about it.

 

[Steve K]

Sorry, Angru.
It has now been stashed away in the back of my garage with the rest of my Gordini stuff.
Make me a decent offer, and I will decide if it is worth going to the trouble of digging it out.

 

[olivier74]

Hi Steve
How would you describe the Super 5 engine condition and does it come with ancillaries? I am assuming it is a C1J turbo?

 

[Steve K]

Hi Olivier,
I can understand the impression of an engine...
But. It is just the heading to identify the model for the listed bits.

 

[olivier74]

Ahhhh.....you got me, I thought I was in luck for a change.
Thanks

 

[Steve K]

The R12 G sway bar is now spoken for....if I can find it!