Kids I am fixing up an old starter motor and need to know where I can get the correct cloth wrap for the field coil, is it anything special? If not I'll go to Spotlight and get some ribbon.
Because the inner is concave I think it may be Adhesive backed Glass Cloth, I recall RS or Farnell may stock itKids I am fixing up an old starter motor and need to know where I can get the correct cloth wrap for the field coil, is it anything special? If not I'll go to Spotlight and get some ribbon.
The 2016 Prius HybridIs this off the same engine as the sump repair?
I didn't realise they made shellac in a spray can, I must get some. Among other things it makes a really good sanding sealer when doing woodwork, and French polishing of course. I have always mixed up the Lac beetle wings with metho at home. It has a thousand uses.Wrapping+ spray cans of insulating material+ shellac spray.
Cheers.
Mmm, probably picked it up cheap after the floods.The 2016 Prius Hybrid
Nice work there Graham, just another thing you need to check and that is that the insulation is lower than the copper segments on the commutator.Well that was a fizzer, I should have known better. I went to a busy auto electrician business today looking for some suitable tape to re-cover the field coil, "we haven't had any of that here for 20 years cos no one repairs starters anymore, we get new parts from China". So it looks like I wait beside the front door for a delivery
In the mean time the starter is being given the treatment. Parts are scrubbed with soapy water and sandpaper, dipped in acid then painted. I made a new cover for the brushes. I must say I am impressed by the mechanical engineering, quality of casting and general sturdiness of this old starter compared to a typical Ducellier or such. Have a look at the end plate containing the brushes, nice. Instead of pulling the whole solenoid apart I was able to peer down into the guts like a crow looking down into a milk bottle and could see that the contact points were serviceable.
After watching a youtube video I tested the armature for shorts and it checks out okay.
View attachment 207073View attachment 207074View attachment 207075View attachment 207076View attachment 207077View attachment 207078
RogerNice work there Graham, just another thing you need to check and that is that the insulation is lower than the copper segments on the commutator.
I've completely given up on paying a professional to do anything cos they are just not interested in old stuff and who could blame them.Nice work there Graham, just another thing you need to check and that is that the insulation is lower than the copper segments on the commutator.
I like the repair option for the home DIY'er because it usually works out a lot cheaper than paying the professionals and is rewarding as shown by your results.
For any kiddies watching this, the acid dipping sequence is thus. Dip the cleaned ferrous casing parts in a strong hydrochloric solution for a coupla minutes to get a good clean etched surface ready for paint. Rinse in fresh water and then put them in soapy water to neutralise the acid. Dry quickly with a hair dryer ( I use a gas torch) then paint them while the metal is still warm. Works a treat.In the mean time the starter is being given the treatment. Parts are scrubbed with soapy water and sandpaper, dipped in acid then painted.