Some advice re the water pump for a 1970 R16 TS. The manual states that the gasket is put on dry, but some other advice I have had said use a sealant as well. I was thinking of using Hylomar to be on the safe side, would this be OK. This is a new water pump, and the surface on the engine block looks to be in good condition. Any advice appreciated.
R16TS water pump
- Thread starter Antoine
- Start date
I use a little Hylomar on one side, the pump side only, not on the head side. It seals very well and easier to remove in future if necessary. I'm sure there will be many other opinions.
I've just used a little grease on both sides of the gasket, comes apart readily and I have never had one leak.
I admit to using grease on the gasket also, and particularly never seize or grease on the bolt threads. Same reason as Col, gasket remains pliable and does not stick.
Thanks for the advice, will go with the grease