Rcz vacuum diagram ep6-cdt

[gazza2012]

Does anyone have a vacuum diagram for a 2010 rcz 1.6 16v , my turbo not kicking in and actuator not moving

 

[seasink]

The solenoid valve for the EP6DT engine is underneath the inlet manifold. Poor access is from below if the manifold is in place. One of the tubes is for atmosphere, it isn't disconnected. The two close together are vacuum in and out. Is this what you need?

Where is Np444nd? A rough location often helps for replies.

 

[gazza2012]

I'm in South Wales

 

[seasink]

I don't think many of us will be recommending suppliers or workshops then, but you never know. Here's the location (the twin tubes at b are vac in and out)--

 

[dmccurtayne]

Why wouldn’t people say where they are from half the people on here must be in witness protection so many people I would offer free help to check the location then nah.

 

[gazza2012]

I don't think many of us will be recommending suppliers or workshops then, but you never know. Here's the location (the twin tubes at b are vac in and out)--
View attachment 218090

Thank you , I'll have a check , can I ask what pipes are going to the vacuum tank ?

 

[gazza2012]

It also looks like there is four pipes on the diagram yet mine only has three , I'm sorry to have to ask but bought this car and it seems someone has messed about with it

 

[seasink]

3 is vacuum receiver
4 is boost control
5 is atmosphere

 

[gazza2012]

Thank you , this is the diagram I have and that's where I think I'm going wrong

 

[gazza2012]

Why wouldn’t people say where they are from half the people on here must be in witness protection so many people I would offer free help to check the location then nah.

Sorry mate , from South Wales

 

[seasink]

I noticed your diagram was labelled RCZ with a 2015 date. My diagrams are generic EP6DT, as in DS3s etc from that time- 2010