crank sensor 505gti auto

stevedriver

New member
Tadpole
Joined
Dec 3, 2010
Messages
8
Location
liverpool
changine engines,, whats the trick putting flex plate on other engine,, top dead centre, remove and replace in same position..
is this correct..does it need to be in same place on both engines.. flex plate placement..

i dont want to have to pull engine out again
 
The sensor in the cover plate that senses the flex plate is for the diagnostic system , not needed for the engine to run , in fact maost have been cut off by now.
The ECU takes engine position from the dissy.
 
Thanks mate.

i am pretty good on the spanners but really had my head in a spin over this sensor as i am unfamilliar with the electrical side of this car,,

thanks for the advice,,its full steam ahead on puting the new motor in this weekend,,finally she will run again and i have enough parts to get it as new..
thanks again
 
Top