607 front brake caliper cradle

[Rikenman]

Hi Guys
I was just replacing the front drive shaft in the 607, unfortunately my torex socket set did not have the size required. Do you know the torex size to remove the two bolts that hold the caliper cradle not the caliper slide bolts.

Thank you

 

[dcc236]

I have one of these, it has all the torx bits I need for the Citroen C5, Pug 307 & 407:

40 x Allen Key Set Socket Bit 3/8"&1/2" Drive Long Deep Torx Star Spline Hex new | eBay

Find many great new & used options and get the best deals for 40 x Allen Key Set Socket Bit 3/8"&1/2" Drive Long Deep Torx Star Spline Hex new at the best online prices at eBay!

www.ebay.com.au

 

[Rikenman]

I have one of these, it has all the torx bits I need for the Citroen C5, Pug 307 & 407:

40 x Allen Key Set Socket Bit 3/8"&1/2" Drive Long Deep Torx Star Spline Hex new | eBay

Find many great new & used options and get the best deals for 40 x Allen Key Set Socket Bit 3/8"&1/2" Drive Long Deep Torx Star Spline Hex new at the best online prices at eBay!

www.ebay.com.au

Thank you

 

[PeterT]

I've been burnt by cheap torx bits. I bought a set of Snap-on T15-T55 twenty years ago and have never regretted it.

 

[DoubleChevron]

Grab an Etorx socket set while your at it .... Its very frustrating being half way through doing something and stumbling across a fastener you haven't seem before. I purchased a set similar to the one shown above years ago. I've been sure I'd break it many times .... but its always managed to undo the very tight (or thread locked) fasteners so far. I've even used breaker bars on the torx bits. The varying length of the socket attachements is very handy. You will also find the allen key sockets and splines handy.