I've just fitted grease nipples in-situ into the rear swing
arms of the suspension on the BX.
Although they show the fitting to a BX, they would also apply to CX and GS
as well as possibly other hydraulic type Cits and possibly Pugs.
Can't speak for sure about Pugs as I don't know for sure the type of rear
suspension they have fitted but possibly it could incorporate something similar.
Cits with this type of system on them require the bearings and spacers to
be fitted as a kit every few years particularly in a wet or snowy climate.
This almost eliminates the job provided that the owner gives thewm a bit of
a pump of grease every year or so.
The dimension for fitting the grease nipples is approx 30 - 35mm from the
outer edge of the arm and central in the area using the bolt which passes
through as the "target" in determining the central location.
Alan S.
