Search Results - aussiefrogs - The Australian French Car Forum Since 1999
  • Register
  • Help

Search:

Type: Posts; User: jaahn; Keyword(s):

Search: Search took 0.10 seconds.

  1. Replies
    53
    Views
    2,209

    Hi Moderator Thank you for correcting that mess...

    Hi Moderator Thank you for correcting that mess :) :)
    For some reason this reply below went beserk and did that wot you see ?? Please deleat the crap and leave the text if possible. I do not seem...
  2. Replies
    53
    Views
    2,209

    Hi :) I have perused that document. Not too...

    Hi :)
    I have perused that document. Not too helpful mainly general statements.

    I cannot argue from here and like always you form a theory and then test it on the car to see if it is good or...
  3. Replies
    53
    Views
    2,209

    Hi :) Well the new mechanic is not being...

    Hi :)
    Well the new mechanic is not being helpfull. :( possible might be correct but expensive ! Why would it suddenly wear out the oil rings ??
    I am still not convinced the crankcase breather...
  4. Replies
    53
    Views
    2,209

    Steve :) That looks like a PCV valve in the...

    Steve :)
    That looks like a PCV valve in the tappet cover with the hose going to it. However somewhere there is also a connection from the crankcase/tappet area into the inlet manifold on the engine...
  5. Replies
    53
    Views
    2,209

    Hmmm oil burning ??

    Hi Steve,:)
    Putting my thinking cap on again :rolleyes:
    While it is quite feasible for all the compression rings to be good and the bores but the oil rings worn/broken I would not think that is...
  6. Replies
    53
    Views
    2,209

    Hi Big Frog :) While I am sympathetic I do not...

    Hi Big Frog :)
    While I am sympathetic I do not believe the removal of the head is ever justified, until it is proven it is really necessary. When I was young and silly and full of energy I would do...
  7. Replies
    53
    Views
    2,209

    Hi Steve:) Sorry about your problem. Had no...

    Hi Steve:)
    Sorry about your problem. Had no direct experience so these are just general ideas.
    To pinpoint the noise better get a length of 1/4" plastic tube from the shed or hardware shop and use...
Results 1 to 7 of 8