3rd to 4th gear is rough and engage too early.
  • Register
  • Help
Results 1 to 3 of 3
  1. #1
    Tadpole
    Join Date
    Sep 2014
    Location
    lalaland
    Posts
    2

    Default 3rd to 4th gear is rough and engage too early.

    hi
    I own a 206 with AL4, year 2007, TU5JP4.
    I noticed that 1st to 2nd, 2nd to 3rd engage fine.
    but 3rd to 4th is engaged too early and hard kick is felt (it engage at 2500RPM at 3rd gear and getting to 1800RPM in the 4th, which cause the acceleration very poor until the RPM raise)
    is it normal or there is something I should check?
    also I noticed in the LEXIA that there is a 100RPM difference between "ENGINE RPM SENSOR" and "INPUT RPM SENSOR".
    best regards.

    Advertisement


    * just to be sure, I already did OIL change, all 3 engine mounts are new *

  2. #2
    Member
    Join Date
    Oct 2013
    Location
    Epping
    Posts
    108

    Default

    At 100 km rpm should be around 2000 if 500 higher the lock up torque converter is not engaging

  3. #3
    Tadpole
    Join Date
    Sep 2014
    Location
    lalaland
    Posts
    2

    Default

    I did recived a fault code "intermittent fault: press control signal fault"
    I did try replacing the pressure sensor - did not helped
    oil have been replaced - no help
    two selonoids have been swaped - no help
    engine mounts are OK
    selector lever is correct.
    I still have a rough kick when changing from 3rd to 4th gear
    in D mode the change appear at +-2400 rpm
    when in TIPTRONIC mode no meter what RPM I still have the kick
    any ideas?
    best regards

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •