Xantia Rims Wanted
  • Register
  • Help
Results 1 to 5 of 5
  1. #1
    Member
    Join Date
    Mar 2011
    Location
    Broken Hill (Outback NSW)
    Posts
    34

    Default Xantia Rims Wanted

    Still looking to buy a couple of alloy wheels to replace the damaged one's on my car at present. Had no luck for some time so thought i'd try this again

    Must be in good condition with no gutter marks.

    Advertisement
    Attached Thumbnails Attached Thumbnails Xantia Rims Wanted-dscf3171.jpg  

  2. #2
    Fellow Frogger
    Join Date
    Jan 2004
    Location
    Sydney
    Posts
    9,821

    Default

    I think these were originally used on V6 and later Exclusive models. Late XM's have wheels that look the same, but have 5 studs, so be sure to avoid them, although they will be uncommon anyway.
    I recall there have been a couple of listings for Xantia wrecking in this section in the past month or so. Check them.
    eBay or Gumtree perhaps?
    You might try Martin Bray in Adelaide or even ASV if you have no luck here.
    Continental Cars in Sydney would most likely have some, but I understand you'd need to actually go there to inspect/collect, which would probably not work for you.
    Last edited by David S; 27th June 2012 at 10:08 AM.

  3. #3
    Contented Peugeot Driver addo's Avatar
    Join Date
    Jun 2005
    Location
    Don't remind me!
    Posts
    16,609

    Default

    There are two types, of different width. V6 cars had the "Magny-Cours" while later SX and similar were kitted with "Le Castellet". Both look the same, but one is J wider.

    The version type is cast into the inner rim edge where your balance weights clip against.

  4. #4
    Fellow Frogger! Balki's Avatar
    Join Date
    Nov 2010
    Location
    Sheffield/Tasmania
    Posts
    626

    Default wheels

    i have a full set will look at them in the next few days to check condition

  5. #5
    Member
    Join Date
    Mar 2011
    Location
    Broken Hill (Outback NSW)
    Posts
    34

    Default

    Thanks for the info David. I have delt with Martin Bray in the past so will give him a call.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •