If it is the type of washer pump Schlitz refers to (the long one), from memory the brass shaft seizes and it's not really recoverable so I agree with...
Lubrication is a whole science when working on watches. Example...Moebius 9415 is used for one purpose only (lubricating the sliding faces of pallet...
Luthier I think the temp issue is just the failsafe when there's a bad connection for the gauge (wiring/sensor). It shows high temp and the STOP lamp...
I changed the belts on my 206 a few weeks ago...I could show you some battle scars! Cut my right arm up a fair bit. This was the tightest belt space...
Or some other options. A bit old, but it gives you some ideas on other types which may be still around or upgraded now. I've seen the Penrite Enviro...
Old thread, but here are some instructions for this job I cobbled together that I got off the internet and added my own tips to to for the next time...
Yeah, I agree. But it just shows how these problems can be tricky. You wouldn't expect two problems but I think that's what happened, so the lack of...
Well what a saga. It turns out the three wires comprise a permanent earth and then two wires controlled by the BSI, positive and another ground. The...
That's it! Same setup. I think it reaches far enough in to press upon the part where it narrows in the female end, but I'm not sure. It doesn't leak...
Leith, I just did a timing belt job on my 206 and it has a similar setup going into what in my case was the plastic water pump around the back of the...
2003 PEUGEOT 206 GTi 
Find latest posts
Likes Received (458)